Command Light KL409D, Manual, Page: 17 / 40

USER GUIDE
17
KL409D (KL Slim) Relay Box Wiring
Tools Required:
• 1/8” Flathead Screwdriver
• #2 Phillips Screwdriver
• Wire Strippers
• 7/16” Nut driver or Wrench
• Wire Crimpers
• Large Cable Crimpers
• Bosch Crimpers
• 15/16”, 1 1/16”, 1 5/8” Wrenches or Channel Locks
• Small torch or lighter
Route Cables from Light Tower to Relaybox
Crimp Large Bosch connectors on the 10 Awg black, red, blue, & orange wires in the larger cable, these
are the Lamp Power wires. Insert the Bosch connectors into the open slot in the relay modules and then
insert the relays.
Crimp 10-12 Awg / ¼” ring connectors on the 10 Awg white, gray, yellow, & yellow/black wires in
the larger cable, these are the lamp ground wires. Put the rings on the ¼” ground stud, the 2 Awg black
cable will go on top of these.