PS2000AN Operator’s Guide
4
Storing the pager code
Before you can use the pagers with the PS2000AN, you must designate a pager code for each of the pagers.
NOTE:
You must reset all pager codes when you enter a new system code.
To enter and store a pager code in either the VM200,
VP200, or the VP201 pagers, follow these steps:
1.
Turn the pager
OFF
.
2.
Press and hold the
ON/OFF
switch, then slide it to
. Continue holding this switch down until the
display shows
(about 5 seconds). The display
then shows an
L
indicating that the pager is ready to
receive a new code.
3.
Make sure that the PS2000AN is turned
ON
, then
enter a 3-digit pager code (000-999) and then
0
.
4.
Press the
PAGE
button on the PS2000AN, and the
unit will transmit the pager code to the pager. The
pager will beep 5 times, and flash
8
on its display,
indicating that it received the message code
0
.
5.
Once the pager code is successfully stored, turn the
pager
OFF
and then
ON
before attempting to transmit
a message code.
Example: If you want the pager to have a new pager
code such as: 450, enter 4500, and press
PAGE
.
After you press the
PAGE
button, the PS2000AN
LED flashes the 4 digits 7 times, and simultaneously
transmits the pager code to the pager. The 4 digits will
remain illuminated until you perform one of the
following actions:
z
Turn the PS2000AN
OFF
z
Press the
CANCEL
button
z
Transmit a message to a pager
Perform the preceding steps for each pager used with
the PS2000AN.
NOTE:
If the pager does not successfully store the pager code, repeat the preceding steps.
Transmitting a message code to a single pager
1.
Turn the PS2000AN power
ON
. (The power switch
is located on the back panel of the PS2000AN.)
2.
Press the
CANCEL
button if the display shows
unwanted pager or message codes.
3.
Enter the 3-digit code for the pager you want to
receive the message, then the one digit message
code that you want to send. If you enter the wrong
pager or message code, press the
CANCEL
button,
then re-enter the correct codes.
NOTE:
You cannot reset either of these codes after
you press the
PAGE
button.
4.
Press the
PAGE
button. The
TRANSMIT
display
lights during transmission, and the pager's display
flashes the message code number 7 times. The 4
digits will remain illuminated until you perform 1 of
the following actions:
z
Turn the PS2000AN
OFF
z
Press the
CANCEL
button
5.
Press
CANCEL
, then repeat steps 3 and 4 if you
want to transmit another message code to another
pager.
Summary of Contents for PrivatePage PS2000AN
Page 1: ......
Page 15: ...AC062402 kr MN080 ...