Command Communications PrivatePage PS2000AN, Operator'S Manual

Page: 11 / 15

PS2000AN Operator’s Guide
8
Reviewing stored message codes
The pagers can store eight message codes. Repe
press the black pager switch to view the stored
message codes one by one, from newest to oldest. A
atedly
ash (-) indicates the end of the stored message codes.
he oldest message code is deleted from
dentical to the last message
ceived, it is not stored.
e codes are erased when the pagers
OFF
g procedures, the PS2000AN isn't reaching my pagers. What can I do to increase
Connect a base station antenna to substantially increase the PS2000AN's transmitting range.
1.
Adjust or reposition the antenna and the antenna ground wire.
2. Check the pager's batteries.
ect pager code.
2.
1. Set both of the PS2000AN base units to the same system code.
d
When the memory is full and a new message is
received, t
emory. m
If a new message code is i
re
All stored messag
re turned . a
Troubleshooting -- helpful hints
After following all operatin
the range of transmission?
1.
Adjust or reposition the antenna to obtain optimum transmitting range.
2.
What can I do to reduce the interference on my phone when using the PS2000AN?
What can I do if my pager doesn't display a message code?
and try again.
1.
Review operating procedures
What do I do if my pager won't receive a message code?
1.
Verify the PS2000AN system code and corr
Complete the steps to store the pager code.
How can I use two PS2000AN base units with multiple pagers?