Step 1-
Press the device push pad to the desired setting. (this can be fully depressed or less than fully
depressed).
Step 2-
While depressing the push pad, apply power. (i.e. presenting the credential to the reader).
Step 3-
Continue to keep pad depressed, the device will beep 6 times, roughly 5 seconds. After the beeps
have stopped, release the pad and now the adjustment is complete. If not to your liking repeat the
three steps. That’s all there is to it.
Setting PTS
2 Beeps
3 Beeps
5 Beeps
6 Beeps
Beeps
Explanation
Solution
Over Voltage
Under Voltage
Forced Release
Push pad is depressed. Device
is re-adjusting
Over-travel or mechanical obstruction
> 28V unit will shut down. Check voltage & adjust to 24 V.
< 22V unit will shut down. Check voltage & adjust to 24 V.
Device will automatically re-engage within 5 seconds.
Check to make sure the push pad is not stuck or catching
on anything.
If mechanical obstruction, remove & push pad down until beeping stops
to reset. If no obstruction, the pad may have been pushed in too far
during PTS calibration. Recalibrate with the pad slightly out. If problem
persists, verify the magnet is within 1/4” of the sensor at the end of
travel.
Troubleshooting & Diagnostics
4 Beeps
Failed Sensor
Verify all 3 sensor wires are installed correctly. Replace sensor if problem
persists by contacting CAT tech support.
**Important Info**
Make sure to set PTS before finishing installation
Technical Information
# 2 0 2 2 7 _ E
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w. c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
mm4s switches
2
on
on
off
STANDARD TORQUE
HIGH TORQUE
PTS PROGRAMMING LOCKED
PTS PROGRAMMING on
off
Average Latch Retraction Current: 2 Amp
Average Holding Current: 250 mA
High Torque Mode
Average Latch Retraction Current: 1 Amp
Average Holding Current: 215 mA
Standard Torque Mode
SPECIFICATIONS
• Input Voltage: 24VDC +/- 10%
• Wire gauge: Minimum 18 gauge
• Direct wire run - no relays or access control
units in-between power supply & module
1
7 Beeps
