Setting parameters 2
2. After completing the previous step of setting, then select the
carving speed, carving power, and the carving size (The carving
power can be set according to the recommended parameters)
5
Tip:
Please make sure the size
of the graphics you need to engrave
and cut does not exceed 400*400
08
1
：
The engraving speed is recommended to use 100-5000.
This is the best value engraving after our repeated experi-
ments. Different materials correspond to different engrav-
ing speeds; Of course, you can increase or decrease this
speed preference according to your needs. A faster speed
will save engraving time, but a slower speed may bring
about the opposite effect of reduced engraving results.
2
：
In the laser mode selection, there are two commands
M3 and M4 for laser on. It is recommended to use the case
where the M4 command is recommended for engraving in
1bit jitter mode, and the M3 command is recommended for
other modes. If your laser only has M3 command, please
check if the laser mode configuration is turned on in GRBL.
For the description of GRBL configuration, please refer to the
official description of LaserGRBL.
3:The choice of engraving energy depends on the different
materials. We have attached the common material
parameters at the end of the engraving and cutting
manual for reference; you can also select our product
model as shown in Figure 3, choose engraving or cutting,
and in selecting the material, the system will provide us
with the default parameters.
4: Finally set the size to be engraved, click the "Create"
button to complete all the settings of the engraving
parameters
