3
3
www.comfortzoneproducts.com
CZAC10BL
Usage:
Operation: Always operate the cooler in the upright position
following all instructions and recommendations listed in this
manual.
Location: Place cooler near you so that the breeze blows
directly on you. This Personal Cooler is designed to provide
direct personal cooling, rather than cooling the entire room.
Control Panel Operation:
On/Off: Plug the power adapter into the back of the unit
and the other end into a 100‑240 Volt AC electrical outlet.
Press the POWER button to turn the unit ON, the unit will
begin operating at LOW speed. Press the power button again
to turn the unit OFF.
Speed: To increase the speed, press the SPEED button, the
speed will change from LOW‑MID‑HIGH speed accordingly,
and it goes around in a circular manner.
LED Light Indicator: The blue LED lights will illuminate
according to the speed. 1 light indicates operating in LOW
speed, 2 lights indicate operating in
mid
speed, 3 lights
indicate operating in HIGH speed.
Filling the Unit with Water:
CAUTION: Before filling the unit with water, unplug the power
adapter from the wall and from the unit.
NOTE: Always use two hands to carry the unit.
Open the cover of the water tank and fill water into the tank
slowly. Water is at maximum level when the red position of the
float bar is visible.
If there are many impurities on the sponge filter, remove the
filter and rinse it off.
Rubber Plug
Care and Maintenance:
Cleaning: CAUTION – Before cleaning the cooler be sure to
disconnect power cord from the plug.
Body: Clean body with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners. DO NOT IMMERSE THE
COOLER OR ANY WIRES IN WATER. Allow cooler to dry
completely before use.
Do not leave standing water in the unit for more than two
days.
Before storage or a long period of inoperation, the water
should be removed from the tray. The tray and appliance
should be completely dried.
If the machine is used for more than three months, mix
detergent and vinegar into water at a ratio of 1:3 and pour it
into the water tank. After soaking for 30 minutes, remove the
rubber plug on the bottom of unit to empty the contents, wash
it again with water, replace the rubber plug, and store it in a
dry and ventilated place.
Speed
On/Off
LED Indicator Lights
Add
Water
Water at
Maximum
Level
Cooler Parts:
Sponge Filter
Water Tank
Power Adapter
Float Bar
Cover
