3
12.
A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint,
explosive and/or flammable liquids are used or stored. Keep unit away from heated surfaces and open
flames.
13.
Do not use an extension cord because the extension cord may overheat and cause a risk of fire.
14.
To avoid fire or shock hazard, plug the unit directly into a 120V AC electrical outlet.
15.
To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO
NOT unplug by pulling on the cord.
16.
Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
17.
Use only for intended household use as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not
recommended or sold by unauthorized dealers may cause hazards.
18.
Always use on a dry, level surface. Use on floor only.
19.
DO NOT use outdoors.
20.
WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state
speed control device.
21.
DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will
void your warranty. The inside of the unit contains no user serviceable parts. Qualified personnel
should perform all servicing only.
22.
Connect to properly grounded outlets only.
23.
SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
Voltage Rating
120 V (60Hz)
Power Consumption
1000/1500W (12.5 Amps), 5120 BTUs
Unit Size
12-
3/4
in. (W) x 20 in. (D) x 17-
3/4
in. (H)
Unit Weight
41.8 lbs
SAFETY FEATURES
Tip-Over Safety Feature
This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will
automatically shut the heater off. Once the heater is restored an upright position, the heater will reset. To
continue operation, turn on the heater using the supplied remote control or the control panel on the heater.
Overheat Safety Feature
This heater is equipped with a overheat safety feature. When the heaters internal components reach a certain
temperature that could cause overheat and possible fire, the heater will automatically shut off. To reset the
heater simply turn the unit off, unplug the heater for about 10 minutes. Plug in and turn it on.
