www.desatech.com
120163-01A
12
INSTALLATION
Continued
INSTALLING REMOTE CONTROL
ACCESSORY BRACKET
If installing optional remote control accessory you
will need to install the remote accessory bracket
for the receiver.
Use screws provided to attach bracket to valve
bracket as shown in Figure 11.
Follow installation instructions included with
remote accessory.
Figure 12 - Attaching Flexible Gas Hose
to Heater Gas Regulator
Gas Control Valve
Flexible Gas Hose
(if allowed by local
codes)
Area of Various Standard Round Flues
Diameter
Area
5"
6"
7"
8"
20 sq. inches
29 sq. inches
39 sq. inches
51 sq. inches
Chimney Height
Minimum Permanent
Flue Opening
6' to 15'
15' to 30'
39 sq. inches
29 sq. inches
Valve Bracket
Figure 11 - Attaching Remote Bracket to
Valve Bracket
Remote
Bracket
INSTALLING HEATER ASSEMBLY
WARNING: If installing in a
sunken fireplace, special care
is needed. You must raise the
fireplace floor to allow access
to heater control panel. This
will insure adequate air flow and
guard against sooting. Raise
fireplace floor with noncombus
-
tible material. Make sure material
is secure.
CAUTION: Do not pick up
heater assembly by logs. This
could damage unit. Only handle
assembly by grates.
IMPORTANT:
Make sure the heater burners are
level. If heater is not level, heater will not work
properly.
Installation Items Needed
• control cover kit (provided with heater)
• approved flexible gas hose and fittings (pro-
vided with heater) (if allowed by local codes)
• sealant (resistant to propane/LP gas, not
provided)
Note:
Install HRC201 Receiver and Hand-Held
Remote Control Kit that is included before in-
stalling gas log heater. See installation instructions
included with the kit.
1. Apply pipe joint sealant lightly to male
threads of gas fitting (not provided). Connect
approved flexible gas hose to inlet side of gas
control (see Figure 12).
2. Position heater assembly in fireplace.
3. Connect to gas supply. See
Connecting To
Gas Supply,
page 13.