ComfortFlame.us.com
900568-00E
19
9. Slightly push in and turn control knob counterclockwise
to
the ON position.
10. Press the on/off key on the remote control to turn on appliance
main burner. Wait at least 5 seconds before setting desired flame
height.
11. Select manual flame height function by pressing MODE button
on remote until a flame is shown in lower left corner of display.
Use the UP/DOWN arrow button to set desired flame height
(see
Figure 37, Page 20
).
12. To leave pilot lit and shut off burners only, turn control knob
clockwise
to the PILOT position, or use remote control ON/
OFF button
Figure 33 - Pilot (Propane/LP)
Figure 34 - Pilot (Natural)
Igniter
Electrode
Pilot Burner
Igniter
Electrode
Pilot Burner
OPERATION
Continued
ON
Figure 35 - Low Battery Display
Low Battery - Remote Receiver
When batteries in receiver are low, no acoustic signal will be given
when ON/OFF button is pressed. If batteries in receiver are low,
fireplace can be switched on manually by moving remote selector
switch to ON
(see
Figure 32, Page 18
).
FAHRENHEIT/CELSIUS INDICATOR
You can set your hand-held remote control to display the temperature
in either Fahrenheit or Celsius. With remote control off, press Ther-
mostat button and Mode button at the same time. This will toggle the
display from °F to °C.
TO TURN OFF GAS
TO APPLIANCE
MANUAL LIGHTING
PROCEDURE
HAND-HELD
REMOTE OPERATION
1. Press on/off key on remote control and turn control knob clockwise
to the OFF position
(see
Figure 32, Page 18
).
2. Close equipment shutoff valve
(see
Figure 22, Page 15
).
1. Follow steps 1 through 7 under Lighting Instructions,
Page 17
.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting pilot.
After 30 seconds, release control knob. Now follow steps 9
through 11 under Lighting Instructions,
Page 18
.
BATTERIES
WARNING: Make sure your selector switch is in
OFF position before installing or changing batteries
in your hand-held remote or receiver.
For installing or replacing batteries in remote control or receiver,
see Installing Batteries in Remote Control and Receiver on
Page 17
.
Low Battery - Hand-Held Remote Control
When batteries in hand-held remote control are low, an icon will ap-
pear on display
(see
Figure 35
).
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
