Operator’s Manual
HP55 Pellet Stove
~ 35 ~
PROBLEM
CAUSE
SOLUTION
Fuel not feeding, no hopper lid
signal on control
Hopper lid is open
Hopper lid switch not functioning
correctly
Close hopper door. Enter the diagnostic area on the
controller; circle next to “limit” should be highlighted
when the hopper lid is closed. The circle will be
unshaded if the hopper lid is opened.
Check hopper door seal.
Replace hopper safety switch if not operating properly.
PROBLEM
CAUSE
SOLUTION
Fire burns lazy and smoky
Stove is dirty
Poor quality fuel
Clean fire pot.
Clean ash pan.
Clean exhaust vent system.
Clean stove through cover plate clean-out hole.
Increase exhaust motor Voltage.
PROBLEM
CAUSE
SOLUTION
Feeds fuel will not light all; control indicators are
on
Igniter tube or burn pot plugged with
ash
Faulty igniter
Clean fire pot, clean igniter tube. Enter the diagnostic
area in the controller and test the ignitor by
highlighting “fire”. You should feel heat coming from
the igniter holder within two minutes.
Replace if necessary
