Operator’s Manual
HP54 Pellet Stove
~ 8 ~
AUTOMATIC SAFETY FEATURES
POWER OUTAGE
During a power outage, the stove will shut down safely.
Do not
open the main door or ash door. During a
power failure the exhaust fan will not run. Keeping the
doors sealed will allow the exhaust vent to draft out
naturally. When the power is restored, the stove will
not restart. If the exhaust temperature is still 120
degrees Fahrenheit when power is restored, the
exhaust and convection fans will continue to run until
the stove cools. See lighting instructions to restart
stove.
Install at least one smoke detector on each floor of your home
to ensure your safety. They should be located away from the
heating appliance and close to the sleeping areas.
You should have another CO monitors for areas near the stove.
OVERHEATING
Over Fire Protection:
If the stove is being over fired or
burning too hot, the high limit switches will
automatically
shut down the stove to avoid damage to
components. If the temperature on the hopper
reaches 200 degree Fahrenheit, the auger will
automatically stop and the stove will shut down. The
exhaust fan will continue to run until the proof of fire
switch cools. Allow stove to cool before attempting
to re-ignite. See lighting instructions
WARNING
If the unit is modified, it will not be compliant with
EPA regulations.
WARNING
If you can see “black smoke ” at the end of the chimney, the
emission maybe have been abnormal.
You should check :
1) If there is an serious clinker in the burnpot.
2) If there are some leakages on the stove for example the
glass door
3) The exhaust channel have been blocked partially.
The input voltage is abnormal
SPECIFICATIONS
Model Number
HP54
BTU/hour output (1)
15.425Btu/hr~47.000 Btu/hr(2)
Heating Capacity (3)
up to 2,800 sq.ft
Electrical
Rating
115 Volts, 60Hz
Efficiency
83.8%
CO Emissions (g/hr) (4)
3.8(min)~16(max)
Particulate Emissions
1.5 g/hr
Power Consumption
525 Watts ignition 75 Watts operating
Fuel Storage Capacity
100 lbs
Flue Size
75mm (3")
Width
640mm (25 1/4")
Height
937mm (37")
Depth
760mm (30")
Weight
94.5kg (208 lbs)
(1)Heat output will vary, depending on the brand, type
and quality of fuel and the moisture content. Consult your
dealer for best results.
(2) This wood heater has a manufacturer-set minimum
low burn rate that must not be altered. It is against
federal regulations to alter this setting or otherwise
operate this wood heater in a manner inconsistent with
operating instructions in this manual.’’
(3) Based on post 1982 home construction, requiring
35 BTU/ Hr. per Sq. Ft.
(4) CO Emissions will vary, depending on the feed level,
burning time and fuel. Consult your dealer for best
results.
GLASS SPECIFICATIONS
This stove is equipped with ceramic glass. Replace glass only
with Qualified ceramic glass.
UNPACKING
Your stove will come fully assembled. Remove all packing
material and tape from the inside of the firebox. Remove any
tape on the outside of the glass. Open the hopper, remove all
packing material and power cord.
NOTE: MAKE SURE THE HOPPER IS FREE OF ALL FOREIGN
MATTER BEFORE FILLING WITH FUEL. FOREIGN MATERLAL
WILL CAUSE AUGER JAMS AND WILL VOID STOVE
WARRANTY.