3. Remove the lid and inner pot, clean with detergent first, then rinse well with
water, and wipe dry with a soft cloth.
4. Clean the internal side of the lid with water, the seal ring, block proof cover,
exhaust valve core and float valve can be removed for washing, timely and
correctly install them after washing, and then dry the internal side of lid with
cloth.
5. Wipe clean the body of the Pressure Cooker with a rag, and it is prohibited to
soak body of the Pressure Cooker in water or spray water to it.
NOTE: Any other servicing should be performed by an unauthorized service
representative.
6. Periodically clean the cooker and remove oil and dirt if it is stored on the table.
7. Place the electric pressure cooker 12cm away from other kitchen appliances.
TROUBLESHOOTING
When followings occur, it is not the cooker fault, please carefully check once
before sending it for repair.
Sealing ring installed
improperly
Install the sealing ring as
required
Food debris attached to the
sealing ring
Clean the sealing ring
Sealing ring damaged
The lid is not closed
correctly
Replace the sealing ring
Close the lid correctly
Float valve gasket worn-out
Replace the float valve
gasket
Food debris on the float
valve gasket
Clean the float valve
gasket
Too little food and water in
inner pot
Steam leaks from the lid or
exhaust valve
Add water and food
according to the recipe
Send to the service center
for repair
S/N
Symptom
Possible Reasons
Solutions
Difficult to open the lid
Float valve in the popped-
up position
Difficult to close the lid
Sealing ring not installed
properly
Position the sealing ring
well
The floater valve clamps
the push rod
Lightly push the push rod
Press the float valve
lightly with a chopstick.
Pressure exists inside the
cooker
Open the lid after the
pressure is completely
released.
Steam leaks from the
lid
Steam leaks from float
valve
Float valve unable to
rise
15
