MT KIT 04
45
MT KIT 04
E
N
G
L
I
S
H
BRAVO KIT SYSTEM EXPANDABILITY
following procedure, and the brackets 5714/K with the
corresponding code (see table on page 39).
For further information on integration of the BRAVO KITS in
Simplebus systems and for programming the main entrance
panel (Art. 4660), refer to the Simplebus 2 catalogue (Catalogue
no. 66), the MT/SB2/01 technical manual and the FT/SB/16
technical sheet.
The diagrams BK/EN/100 and BK/EN/101 on page 90, 92, in
section A of this manual, show a possible system configuration
for managing up to a max. of 30 BRAVO KITS with one Art. 4660
placed, for example, at the entrance of a residential complex.
With these system diagrams it is possible to call one of the
BRAVO KITS from the main entrance equipped with Art. 4660.
In this configuration it is necessary to programme the pushbuttons
of Art. 4660/BK on Art. 4875/BK or 4876/BK as described in the
Programming Art. 4660/BK
1.
On the terminal block of module Art. 4660/BK, connect the
power supply to ~ ~, set the switch to programming (red)
(see figure 1A).
Connect the terminal block to module Art. 4660/BK
assembled as shown above.
NOTE:
For connection between the terminal block and
module Art. 4660/BK during the programming stage it is
possible to use the cable Art. 3309, available as an optional
accessory (figure 2).
2.
Set the Dip switch located on the back of the audio-video
module, with the same code assigned to the telephone or
monitor according to the matching described in the
programming table on page 39.
3.
Press the pushbutton to be associated with the telephone call
or monitor. A tone signal confirms programming.
4. At the end of programming, set the switch to standby
(white) (figure 2A).
1
2
3
4
5
6
7
8
ON
DIP
Art. 3309
Fig. 1A
Fig. 2A
Fig. 1
Fig. 2
