13
Changing the ringtone
Programming reset
1.
Press and hold
for 6 sec.
»
a confirmation tone is emitted
»
the LED
flashes
√
the procedure can only take place while the system is in standby; otherwise the LED
will flash 4 times to inform the user that the
system is busy
2.
Press and release the button
once
(1 confirmation tone sounds) to change the ringtone for calls from the external entrance panel.
twice
(2 confirmation tones sound) to change the ringtone for calls from the switchboard.
3 times
(3 confirmation tones are emitted) to change the ringtone for intercom calls made from the door entry monitor.
4 times
(4 confirmation tones sound) to change the floor door call ringtone.
Any further pressing of the button repeats the sequence described above.
3.
Press and release to scroll through the available ringtones in sequence.
4.
Press to confirm selection of the last ringtone heard and to exit change ringtone mode.
»
a confirmation tone is emitted
»
LED
switches off
5.
Repeat steps 1 to 4 to change the other ringtones.
Factory settings:
• Button functions for the S2 DIP 1-2-3-4 combination
• Intercom address absent
• Range function and min./max. addresses absent
• Ringtone reset
• “Automatic door opening on receipt of call” and “Silent” mode disabled
1.
2.
3.
Take note of the
S1, S2 settings and
restore them when
programming
is
complete.
Set the DIP-switches as shown in the figure.
S1
S2
x4
x10
OK prog:
KO prog:
x4
x10
OK prog:
KO prog:
5 sec
