31
1.
Check “Enable” check box to activate motion based alarms. If unchecked, the
camera will not send out any signals to trigger motion-based recording to the NVR or
Comelit Advance VMS, even if there is motion in the video.
Alarm Out:
If selected, this would trigger an external relay output that is connected to
the camera on detecting a motion based alarm.
Trigger Audio Alarm
: If selected, the warning voice will be uttered on detecting a
motion based alarm (please set the warning voice first. See
Trigger SD Snap:
If selected, the system will capture images on motion detection and
save the images on the micro-SD card.
Trigger SD Recording:
If selected, video will be recorded on the micro-SD card on
motion detection.
Trigger Email
: If
“Trigger Email” and “Attach Picture” are checked (email address
must be set first in the Email configuration interface), the captured pictures and
triggered event will be sent into those addresses.
Trigger FTP
: If
“Trigger FTP” is checked, the captured pictures will be sent into FTP
server address. Please refer to FTP configuration chapter for more details.
2. Set motion detection area and sensitivity. Click the “Area and Sensitivity” tab to go
to the interface as shown below.
Summary of Contents for IPTHBCAMA05F01A
Page 24: ...18...
