Comelit HFX-9000M, Technical Manual, Page: 27 / 129

27
EN
4.2.2 Quick programming
For the quick programming of the following functions:
• generic actuator (ACT),
• internal intercom calls (INT),
• internal paging calls (PAG),
• Self ignition main external unit (AI),
• Doctor mode (D)
1
„
Set the S2 DIP switches
combination corresponding to
the functions that you want to
programme
for ALL KEYS as
shown in the table "4.2.1 Preset
function" .
Example:
Choose S2 DIP switches combination
DIP 1 DIP 2 DIP 3 DIP 4
0 1 0 0
for set all the following function
INT INT ACT NULL AI
PAG
4.2.3 Special key programming
If the preset function (see page 26 "4.2.1" ) do not reflect requirements, EACH KEY can be programmed differently by carrying out the
steps below.
Special key programming allow to programm the following functions:
• generic actuator and coded actuator (ACT),
• internal intercom calls and general intercom calls to another user code (INT),
• internal paging calls and general paging to another user code (PAG),
• Self ignition main external unit (AI),
• Doctor mode (D)
4.2.3.1 HOW TO PROGRAM THE ACTUATOR FUNCTION
Example: key
√
Take note of the S1 setting and restore it when programming is complete
1 Enter programming mode
„
Set S2 DIP switch 5-6 to the combination 01
» the Privacy LED flashes
2 2.1 Choose the function: refer to the "4.2.1 Preset function" table and select a S2 DIP
switches combination in which the actuator function ( ACT ) is listed for the keys you wish to
program.
Example: 0100
2.2 Addressing:
„ for generc actuator set S1 DIP switches to the combination 11111111
„ for coded actuator set S1 DIP switches with the desired address,
see page
32 "TAB.
A" .
3 Select the key to be associated with the function
„
Press and release the key to be associated with the function
» the lock-release LED lights up
» a confirmation tone will sound.
4 Exit programming mode
„
To exit programming mode, set S2 DIP switches 5-6 to the combination 00
» the Privacy LED switches off
5 When programming is complete,
„ S
et
S2
DIP switches 1-2-3-4 to the combination 1111 (
PROG
setting). In this DIP switch
setting, the keys control the programmed functions; the NON-programmed keys control
functions referred to on line 0000. Page
26 "4.2.1 Preset function"
table.
„
Restore the user code setting on S1.