GROUP S.P.A.
MT KIT 10
44
E
N
G
L
I
S
H
Special programming Art. 4660KC
A number of special programming operations can be carried out on
Art. 4660KC according to the various system requirements.
1.
On the terminal block of articles 4660KC, set the switch to
programming (red) (Figure 1A).
2.
On the microswitches of the article (Figure 2), set the code for
the function to be programmed. Use the following table as a
reference.
3.
On the terminal block of articles 4660KC, connect terminal
S with – (Figure 3).
4.
Wait for a programming confirmation tone and remove the
jumper between terminal S and -.
5.
At the end of the procedure, make sure to have set the switch to
standby (white) (Figure 2A), removed the jumpers between
terminals S and - and turn all the microswitches to OFF (0) as
shown in Figure 4.
To carry out another special programming, repeat the above
operations from point 1 to point 5.
1
2
3
4
5
6
7
8
ON
DIP
Art. 3309
Fig. 1A
Fig. 2A
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Dip switches ON
Configuration reference
number
10-second reset wait time (factory setting)
1,2,5,6,7,8
243
1-second reset wait time
3,5,6,7,8
244
Deactivation of door lock confirmation tone and door lock time setting 2 seconds
(factory settings)
1,3,5,6,7,8
245
Activation of door lock confirmation tone
2,3,5,6,7,8
246
Door lock time 8 seconds
1,2,3,5,6,7,8
247
Sending single call (factory setting)
4,5,6,7,8
248
Sending call repeated 3 times
1,4,5,6,7,8
249
Door lock release control normally open (NO) (factory setting)
2,4,5,6,7,8
250
Door lock release control normally closed (NC)
1,2,4,5,6,7,8
251
Door lock release active even with no call (factory setting)
3,4,5,6,7,8
252
Door lock release only enabled for the user called
1,3,4,5,6,7,8
253
Reset of all factory settings
2,3,4,5,6,7,8
254
