27
MT KIT 10
E
N
G
L
I
S
H
MT KIT 10
• Wall-mount the box 160÷165 cm
from the finished floor,
in an area where it is easy to see
the visitor.
Possibly not towards the sun or
other direct light sources (lamps,
reflective surfaces, etc.)
• Fix the frame on the flush-
mounting box using the 2 screws
supplied.
• Insert the terminal block and
connect the wires according to
the diagram.
• Fit the snap-on module onto the
terminal and fix it with the 2
screws provided.
160 - 165 cm
Carla
Rossi
+
-
+
-
Carla
Rossi
OPEN
1
2
3
CLOSE
+
-
+
-
MIC
4
5
2
3
1
• Remove the stainless steel front
to carry out volume adjustments
and adjust the camera.
NOTE: Loosen the four screws
slightly to unlock the camera
and allow adjustment.
• Alternative microphone position.
• To remove name tag holder,
insert the tip of the screwdriver
in the middle opening and
extract it.
• After adjusting, fix the trim by
means of the 2 bottom screws.
NOTE: To remove the trim,
undo the 2 bottom screws,
turning max. 360°.
Installation instructions Art. 4875KC, 4876KC
