19
If the default settings (see table on page
) do not reflect requirements, the keys can be programmed differently by carrying
out the steps below.
At the end, set S2 DIP switches 1-2-3-4 to the combination 1111 (PROG setting in the configuration tables on pages
). In this dip switch setting, the keys control the programmed functions; the NON-programmed keys control
functions referred to on line 0000 (see table on page
). Restore the user code setting on S1, see table A on page
.
Warning
Programming/deleting intercom address
Selective intercom addresses
You must set the intercom address on all the riser’s internal units.
You can assign the same intercom address to a maximum of 3 internal units.
For group calls, select the desired intercom codes simultaneously (max. 3).
Advanced monitor configuration
Programming for intercom call
General intercom: function allowing calls to one or more internal units identified by the same call address as used
by the external unit.
Selective intercom: function allowing calls to one or more internal units identified by a dedicated call address (see
) which is different from the one used by the external unit.
General and selective intercoms CANNOT be used together on the same riser.
Take note of the S2, S1 setting and restore it when programming is complete
1)
2)
3)
Programming; set code,
TAB. B on page
S1
S2 DIP
1 2 3 4 5 6
0 0 0 1 1 1
S2
Cancellation
DIP OFF
DIP ON
S1
S2 DIP
1 2 3 4 5 6
1 1 1 1 1 1
S2
TAB. B
Code
Dip switch ON
S1
Code
Dip switch ON
S1
1
1
5
5
2
2
6
6
3
3
7
7
4
4
8
8
