Operation Manual – Art. 80153 (Version 1.1.6)
13
4.3 Monitor Connection
To display video image from cameras on the monitor, the DVR’s video output signal should be transferred
to your TV set or monitor.
Connect “VIDEO IN” of the monitor to “VIDEO OUT” of the DVR system.
4.4 Camera Connection
Connect between “VIDEO IN” of your DVR and “VIDEO OUT” of camera with video cable and plug in the
camera’s power adapter.
4.5 Sensor Connection
Our 4 CH DVR system can connect up to four sensors.
There are two steps for sensor installation.
(a) Connect the sensor signal lines to the signal input terminal.
(b) Connect the sensor power lines to the appropriate power source.
In general, there are three different types of sensors available in the home electrics store, where you can
buy them. (1) Normal-Close. (2) Normal-Open. (3) Normal-Close & Open. Below is the brief diagram
about how the each type of sensor is installed into DVR. The procedure for sensor install action is as shown
below.
* After you install sensor(s), change the recording mode as “Sensor record” or “MD & Sensor record” on
“RECORD SCHEDULE” in the DVR menu to enable sensor recording.
Connect a monitor at “VIDEO
OUT” ports on DVR
“VIDEO IN” port on MONITOR
“VIDEO OUT” port on DVR
“VIDEO IN” on DVR
“VIDEO OUT” on CAMERA
