Comelit 40799, Manual, Page: 46 / 48

40
Appendix E — Wall Mount
1. Select a suitable mounting location and verify there is sufficient cable to reach the middle of
the Wall Mount.
2. Mark and drill mounting holes in the surface using the Wall Mount Flange.
3. Pull out cables required to connect to the dome camera from the wall or route cables through
a section of 0.75 in. (19mm) conduit pipe.
4. Remove the access plate from the wall mount bracket.
5. Attach the wall mount bracket using screws routing cables through the access plate’s hole.
6. Attach the housing’s safety wire to the wall mount’s latch.
7. Fix the housing to the wall mount bracket using the locking nut after routing cables through
the wall mount bracket and tighten the housing set screw with the supplied wrench.
8. After connecting cables, attach the access plate.