Program Levels
7
With cases 'L' and 'M',
use
instead of
.
Programming order
♦
Set full access to device parameters.
♦
Adjust the parameters.
♦
If needed, restrict the access again
by adjusting the
Access Control Level
parameter.
Access control (Hidden level)
♦
Hold
depressed while turning
the power supply on and until
Qxl
appears.
♦
Set access level according to Table 1.
Basic level
At power-on, TI08 enters Basic level.
At this level, the device indicates
the measured input value (PV)
with a resolution, according to
the
Point Position
parameter.
♦
If the whole part of PV cannot be
entirely displayed, the unit generates
a blinking 'overflow' message
(
oL
or
-oL
, depending on PV sign).
♦
If PV is out of the device physical
operating range, it displays
blinking symbolic message:
<__>
(under-range) or
{++}
(over-range).
♦
Upon entering Basic level, TI08
may display the
init
message,
indicating that some time is necessary
for filter initialization.
♦
The
noiS
message may appear
as a result of the peak filter operation
(see '
Input filtration
').
Set-point adjustment (Level L1)
♦
To enter
Set Point 1
adjustment mode,
press and hold
until
%[1
appears on the display. Release the
key to view the set-point value.
♦
To enter
Set Point 2
adjustment mode,
follow the same procedure,
but start with the
key.
