Comdial Executech 2232, Manual

Page: 33 / 80

'IMI 66-047
Programming
CLASS OF SERVICE DEFAULT
The system can be defaulted to a standard class of service per the
following procedure. The default conditions are listed at the
beginning of each COS programming procedure and shaded on the
programming reference charts.
1
Press ITCM * 7 4 6 *
2 Press program key C38
3 Press keypad key(s) to choose default settings
1 = system COS default 4 = pulse dialing all lines
2 line COS default
5 = tone dialing all lines
station default
6
flexible key/function default
= One column SMDR line = Two 40 column SMDK lines
RECALL = Tape baud rate of 100
SAVE = Tape baud rate of
7051684 = master default (CAUTION: resets all values
and clears all stored Do not perform
while system is in use)
4 Press * MONITOR
OVERLAYS
Several different telephone and console overlays are packed with the
system. The overlay to be used is dependent upon the particular
models of equipment connected to the programming station port (10 or
11) and the respective console port or
The programming
overlays are illustrated in Figure 3-l.
Full-scale copies of the
overlays are also included at the end of this chapter.
The full-scale
copies can be removed and prepared for use if needed.