7
www.combisteel.com
Night cover (7464.0315, 7464.0320)
This section is fixed onto the front upper section of the cooler. The cover should be drawn to save energy during
those times when any product is not to be taken from the cooler other than working times. Open the cover by
pulling the handle and attaching to the cover holder on the front section of the cooler. When you want the cover
closed again, spring mechanism will automatically be activated upon removing from the holder and rewind the
cover.
Air curtain (honeycomb & vent sheet)
This is an air current generated on the front section of the cooler to prevent cold air within the cooler getting
affected by outside air. Air blown from inside the honeycomb behind the nigh cover on the upper section of the
cooler is absorbed by the absorbance vents on the lower section of the cooler to produce a current. Honeycomb
and vent sheet should not be hindered to prevent air current from getting affected and low performance of the
cooler.
Attaching the shelves
First fit the upmost shelf into the spaces on shelf carrying profiles on the back corners of the cooler with upper
claws into the space, and then after installing the 2
nd
claw, press slowly on the shelf to make it properly fit into
the space. Then with the same method attach the other shelves. The materials inside the cooler are cooled by
air circulation so do not place the shelves close to each other.
Defrosting
Cooling process performs automatic defrosting thanks to thermostat control for models 7464.0315 and
7464.0320. Water produced after defrosting accumulates in a channel under water evaporator and conducted
to drain pan through a pipe and evaporated. The models 7464.0300, 7464.0305 and 7464.0310 require manual
defrosting.
Defrosting might be accelerated by placing a cup of hot water (not boiled) under the cooler.
Clean the device after defrosting and wipe water and humidity inside. Plug in the device again and refill the
cooler after one hour.
Replacing the fluorescent lighting: (if your product has fluorescent lamp)
Before dismantling the lamp, always unplug your cooler. After dismantling the lamp cover inside the cooler,
remove the lamp and always replace it with a lamp of the same features (length, power, etc.)
Summary of Contents for 7464.03 Series
Page 4: ...4 www combisteel com...
