8
CLEANING
WARNING
To prevent any electrical shock hazards or injury by rotating circulation fan, always
disconnect the power cord plug from the wall outlet before cleaning.
Exterior and cooler compartment
Wipe the exterior and cooler compartment of the unit with a soft, dry cloth. If very soiled, wipe with a cloth that
has been moistened with a detergent. Then wipe with a cloth that has been dipped in water.
WARNING
Do not splash water directly onto the cooler and do not wash with water.
Short-circuiting and electrical shock could result.
Clean the cooler regularly to keep it clean at all times.
Never use polishing powder, soap powder, gasoline, oil or hot water
as these will damage the painting and plastic components.
Checks after cleaning
To ensure the safety, perform the following checks after cleaning the unit.
Make sure that the power plug is firmly inserted into a dedicated wall outlet. Confirm that the plug is not
abnormally hot.
Check the power cord for cracks and damage. Should the slightest irregularity be observed, contact the
dealer form whom you have purchased the unit.
TROUBLESHOOTING
In case the unit shows operating problems, check the following before calling the authorized service agent.
Problems
Possible Causes
Possible Solutions
The unit is not operating
Faulty electrical contact
Verify electrical connections.
Poor electrical power
Check the power connection and
electrical outlet.
Thermostat set to the minimum
position
Adjust the thermostat setting to a
higher number.
Not reaching the desired
temperature
Unit is exposed to direct sunlight.
Relocate the unit to a shaded area.
Thermostat is not properly adjusted.
Adjust the thermostat setting to a
higher number.
Door(s) not properly closed
Check the levelling of the unit and
door seal.
Products poorly distributed or excess
product load
Redistribute the product load
according start instructions.
Clogged condenser
Clean the condenser.
Blocked grills
Clean the grills of any debris collected.
For models with electronic
temperature controller, indicates E0 or
E1.
Unplug the unit from the outlet. If the
error continues, contact an authorized
service technician.
Excessive noise
The unit is not properly levelled.
Level the unit, making sure all the feet
are in firm contact with the floor.
Something is in contact with the
appliance, e.g. boxes, mops, brushes,
etc.
Keep the objects away from the
appliance.
Water on the floor
Drain hose is outside of the drain pan.
Lovate the hose in the drain pan.
