CombiSteel 7065.0005, User Manual

Page: 10 / 34

10
www.combisteel.com
Troubleshooting
PROBLEM CAUSE SOLUTION
The dispenser is not
working 1- The master key is in position “0”
2- The dispenser may not be
connected to the electricity 1- Bring main switch to position “1”
2- Connect the dispenser to the
electricity.
The tap constantly drips 1- Tap gasket is not properly fitted.
2- Tap spring is not properly fitted. 1- Check if the gasket is properly fitted
2- Fit the spring properly in place.
The beverage is flowing
from different points of
the machine. 1- The bowl is not properly fitted in
place.
2- The bowl and the gasket are not
properly lubricated with Vaseline.
3 - The gasket is damaged 1- Fit the bowl in place as shown in this
manual.
2- Lubricate the bowl and the gasket
3- Replace the gasket with a new one
White helix mixer does not
turn 1- The key is in position “0”
2- The metal tower is covered with ice
preventing the helix to turn. 1- Bring switch to position “I”
2- Turn off the cooling and wait for the
ice to melt, Do not use hot water.
The dispenser does not
produce granita 1- C is in position (I)
2- The dispenser has been placed near
a heat emitting machine
3 -Insufficient air flow
4- The condenser is dirty
5- Density is not properly adjusted 1- Change C to (II)
2- Change the place where the
dispenser has been installed.
3- Make sure there is enough air flow
by securing 15cm on each side of the
dispenser
4- Clean the condenser
5- Adjust density with the switch
White helix mixer is
making high noise while
turning 1- The nut holding the white helix
mixer may not be properly installed.
2- The front gasket is not properly
lubricated.
3- The metal tower is covered with ice 1- Make sure the nut is properly
installed
2- Lubricate the gasket
3- Turn off the cooling and wait for the
ice to melt, Do not use hot water.