Changing Harness Use Position
Shoulder harness straps
must
be through slots
at
or
just below
shoulder.
To change shoulder belt slots:
1. Buckle harness and chest clip.
2. From front of car seat, loosen harness straps by pressing harness adjuster lever and
pulling harness straps out to lengthen them.
3. From back of car seat, rotate harness safety cover out, unhook both harness
strap metal clips from adjuster loop
(fig. a)
.
4. From front of car seat, pull harness straps out through car seat shell, seat pad
and infant insert.
To Re-secure Harness Belts:
1. From front of car seat, rethread harness straps through desired harness strap
slots of infant insert, seat pad and seat back.
NOTE:
Only use two lowest sets of shoulder belt slots with infant insert.
2. From back of car seat, route shoulder belts between plastic seat
and metal rod. Pull harness straps down and re-attach harness
strap metal clips to adjuster loop as shown in
fig. c
. Make sure
harness straps are not twisted and are threaded through
matching slot of seat pad and seat back.
3. Close harness safety cover, snap onto metal rod.
22
(fig. a)
Harness
Strap Metal
Clip
(fig. c)
Adjuster
Strap
Loop
Section 11 - Operation and Adjustment
WARNING
•
Shoulder belts MUST be through belt slots in infant insert.
•
Do not use infant insert with top slots in car seat.
Harness
Safety
Cover
Metal
Rod
Adjuster
Loop
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 23
