InteliLite 4 MRS16 Operator Guide
21
Note:
Use Enter button to confirm the PIN and Loging or Page button to cancel entering the Login.
Note:
In case that invalid UserID or PIN are entered, the controller shows Wrong Credentials screen. Use
Enter button to enter Login again or Page Button to go back to menu.
4.1 Account break protection
The controller is protecting the user accounts against breaking by a brute-force attack, i.e against breaking into
the controller by fast repeating attempts to login with credentials generated from the range of all possible
combinations.
If the account break protection detects a possible attack and blocks an account or interface the alarm
Wrn Brute
Force Protection Active
is activated. The alarm can be used to send an active message (e.g. e-mail) to inform
about that situation The detailed behavior of the controller depends on situation.
4.1.1 PIN protection
If an user performs
ten consecutive attempts
to login using UID/PIN, providing
correct UID
but
incorrect
PIN
, the user account is permanently blocked for login using UID/PIN. The user must login with
username/password and change the PIN to unblock this login method again.
4.2 Reset accounts to factory default
If credentials (username and/or password) for administrator account are lost, it is possible to reset all user
accounts to the factory default state. For more information
see Resetting the administrator password on
.
After reset procedure user accounts are in factory default state.
Wrn Default Password appears in alarmlist when the default administrator password is set and communication
module is plagued in the controller. The purpose of alarm is to inform that the controller might be or is connected
to the untrusted interface and cybersecurity rules are not fulfilled cause there is default administrator password.
