22
DAILY MAINTENANCE
REPLACEMENT OF THE SQUEEGEE RUBBER
If the squeegee rubber is worn and does not dry well, it is possible to change the
drying edge proceeding as follows:
1.
Push and rotate the fixing plates
2.
Slip off the rubber blade and the rubber itself
3.
Turn the rubber upside-down and if necessary, replace it
4.
Adjust the squeegee height as indicated in “ADJUSTMENT HEIGHT SQUEEGEE
SUPPORT” under “MACHINE PREPARATION”
5.
Reassemble everything repeating inversely above operations
DISASSEMBLY OF THE BRUSHES
1.
Connect the battery connector if it is not connected
2.
Turn the key into position ON
3.
With the manipulator lift the brushes base
4.
Turn the key into position OFF and take if off from the instrument board (to carry
out the operations of brush disassembly with connected current can cause
damage to the hands)
5.
With the brushes base in lifted position, rotate the brush until it comes off from
the brush plate seat as shown in the figure. The figure shows the rotating
direction for the disassembly of the right brush, the left one has to be rotated
inversely.
