16
MACHINE PREPARATION
19. DETERGENT SOLUTION (VERSIONS WITHOUT CDS)
1.
Check the switch key is set to "0" (for the electric version, check that the power cable is unplugged
from the mains).
2.
Apply the parking brake by pulling the lever and blocking the handle with the pin.
3.
Make sure the recovery tank is empty before opening, if full empty it.
4.
Remove the front solution tank cap and fill with clean water at a temperature not exceeding 50
C.
The amount present in the tank can be seen through the rear level tube (1). The solution tank has
a maximum capacity of about 60 litres.
5.
Add the liquid detergent to the tank in the concentration and manner indicated on the detergent
manufacturer's label. The formation of excess foam could damage the suction motor, so use only
the minimum amount of detergent necessary. In addition, you are advised to always use low foam
detergents. Do not use pure acids.
WARNING: always use detergents whose manufacturer's label indicates their
suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication. In addition, you are advised to always use low
foam detergents. Do not use pure acids.
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands
20. DETERGENT SOLUTION (FOR VERSIONS WITH CDS ONLY).
1.
Check the switch key is set to "0" (for the electric version, check that the power cable is unplugged
from the mains).
2.
Apply the parking brake by pulling the lever and blocking the handle with the pin.
3.
Make sure the recovery tank is empty before opening, if full empty it.
4.
Release the hinges (1) on the handlebars.
5.
Rotate the recovery tank as far as it will go, using the side handle (2).
6.
Unscrew the cap (3) of the canister in the compartment (behind the batteries) and fill it with liquid
detergent in the manner indicated on the label supplied with the machine.
7.
Check the screw cap is well closed, to avoid any liquid leaking out while the machine is being
used.
8.
Close the recovery tank, rotating it by hand. Only hold the recovery tank by the handle (2), to avoid
crushing your hands.
1
1
2
3
