15
MACHINE PREPARATION
15.
ADJUSTING THE SQUEEGEE INCLINATION
During working operation, the rear rubber is tilted slightly backwards (by about 5mm) in a uniform way
for its whole length. If it is necessary to increase the bend of the rubber in the central part, you must tilt
the squeegee backwards, rotating the adjuster (1) anticlockwise. To increase the bend of the rubber at
the sides of the squeegee, rotate the set screw clockwise.
16.
ADJUSTING THE SQUEEGEE HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear and tear of the rubber.
To do this, turn the knob (2) anticlockwise to raise the squeegee, and clockwise to lower it.
Remarks: the right and left wheels must be adjusted to the same level, so the squeegee can work
parallel to the floor.
17.
RECOVERY TANK
Check the cap of the drainage tube (on the rear of the machine) is correctly closed.
ATTENTION: To avoid foam production, put a minimum quantity of antifoam
liquid in the recovery tank before starting to clean
18. SOLUTION
TANK
The recovery tank must be completely empty each time the solution tank is filled.
Remove the front-mounted hopper (1) and check the solution filter (2) is correctly assembled.
Check that the detergent solution filter cap (3), located at the rear of the solution tank, is properly
closed.
2
1
1
2
3