HOW TO UNPACK THE MACHINE
The machine is shipped in specific packaging. To remove it, proceed as follows:
1.
Place the lower part of the outer packaging in contact with the floor.
N.B.
: use the pictograms printed on the box as a reference.
2. Remove the outer package.
WARNING
: the machine is contained in specific packaging materials, whose elements (plastic bags, staples, etc.) can pose potential hazards,
and must not be left within reach of children, disabled persons, etc.
CAUTION
: it is recommended to wear the appropriate PPE (Personal Protective Equipment) for the work to be carried out
.
3. Insert a ramp in the rear part of the machine.
ATTENTION
: the ramp gradient must not be such as to cause damage to the machine as it comes down.
4. The machine is fastened to the platform with wedges, remove these wedges.
5.
Take the machine off the pallet via the ramp.
CAUTION
: during this operation, check there are no people or objects near the machine.
HOW TO MOVE THE MACHINE
To transport the machine safely, proceed as follows:
1. Check that all the machine tanks are empty; if this is not the case, empty them (see “
” and also
“
EMPTYING THE MEMBRANE SETTLING TANK
EMPTYING THE DEGREASER SETTLING
”).
2. Place the machine on the transport vehicle.
WARNING
: secure the device according to the directives in force in the country of use (ex. 2014/47/EU), , so that it cannot slide or tip over.
MACHINE SAFETY
The procedure for securing the machine, thus allowing the operations to be performed under conditions of complete safety, is as follows:
1. Sit on the driver’s seat.
2. Check that the main switch on the control panel has been set to “0”. If this is not the case, turn the key a quarter turn anti-clockwise (
Fig.1
).
3. Remove the key from the main switch.
4. Shift the direction lever to the “idle” position, moving it in the direction shown by the arrow (
Fig.2
).
5. Disconnect the battery connector from the machine's main system connector (
Fig.3
).
2
1
3
PREPARATION OF MACHINE
11
