COMAC C85 2018 BS NSC BASIC, Use And Maintenance Manual

Page: 20 / 32

AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1. Take the machine to the maintenance area and perform all of the procedures listed in the chapter “ COMPULSORY MAINTENANCE
OPERATIONS ” in the “DAILY” section.
2. Once the maintenance operations are complete, take the machine to the designated storage location.
ATTENTION:
Park the machine in an enclosed place, on a flat surface, and at a safe distance from any objects that could either damage it
or be damaged due to contact with the machine itself.
3. Make sure the machine is in a safe condition, see chapter “ MACHINE SAFETY MEASURES” .
COMPULSORY MAINTENANCE OPERATIONS
Before performing any routine or extraordinary maintenance operation, proceed as follows:
1. Take the machine to the maintenance area.
N.B.
: the place designated for this operation must comply with current environmental protection regulations.
2. Make sure the machine has been secured (see the chapter entitled “ SECURING THE MACHINE ”).
CAUTION : it is recommended to wear the appropriate PPE (Personal Protective Equipment) for the work to be carried out .
20
INTERVAL MACHINE COMPONENTS PROCEDURE
DAIL
Y
Squeegee
Clean the vacuum chamber; the squeegee rubber blades; the vacuum nozzle (see
“ CLEANING THE SQUEEGEE BODY ”).
Debris hopper
Empty the debris hopper and clean inside (see “ EMPTYING THE DEBRIS HOPPER
”).
Brush head brushes Clean the brushes (see “ CLEANING THE BRUSH HEAD BRUSHES ”).
Recovery tank basket-filter Clean the recovery tank basket-filter (see “ EMPTYING THE RECOVERY TANK ”).
WEEKL
Y; BEFORE
A LONG PERIOD OF INACTIVITY
Recovery tank
Every working week, empty the recovery tank (see “ EMPTYING THE RECOVERY
TANK ”).
Solution tank
Every working week, empty the solution tank (see “ EMPTYING THE SOLUTION
TANK ”).
Degreaser settling tank
Every working week, empty the degreaser settling tank (see “ EMPTYING THE
DEGREASER SETTLING TANK ”).
Membrane settling tank
Every working week, empty the membrane settling tank (see “ EMPTYING THE
MEMBRANE SETTLING TANK ”).
Machine water system
Clean the filter in the machine's water system (see “ CLEANING THE WATER
SYSTEM FILTER ”).
Squeegee rubber blades
Check that the rubber blades on the squeegee body are intact and inspect for wear;
if necessary, replace these (see “ REPLACING THE SQUEEGEE BODY RUBBER
BLADES ”).
Brush head brushes
Check that the brushes on the brush head body are intact and inspect for wear;
if necessary, replace these (see “ REPLACING THE BRUSH HEAD BODY
BRUSHES ”).
Lateral brush head body brush
Check that the side brush is intact and inspect for wear; if necessary, replace this
(see “ REPLACING THE SIDE BRUSH (OPTIONAL) ”).
MONTHLY Squeegee rubber blade levelling
Check that the rubber blades on the squeegee body are level and if necessary,
adjust these (see “A DJUSTING THE SQUEEGEE BODY RUBBER BLADES ”).