Page 19 of 28
INSTRUCTION MANUAL
LI-3P-1x Series
3-PHASE LINE IMPEDANCE STABILIZATION NETWORKS (LISNs)
SECTI ON 4 -
PRODUCT APPLICATION
1912 1 E l T o ro R d
●
Si l vera do, Ca lifo rni a 9 26 76
●
(9 49) 459 -96 00
●
co m-p o wer. com
REV083017
4.3.2
LISN Output Power Connections
Your LI-3P-1x Series LISN is provided with a five-conductor plug connector
(with male contacts), which is used to connect the LISN to the input
power cable for the Equipment Under Test (EUT). It mates with the output
power socket connector affixed to the front panel of the LISN. Illustrated
in Figures 8 (16/32 Amp) and 9 (63/100 Amp) are the respective installation
instructions for the connector.
FIGURE 8 -
Wiring Instructions for EUT Power Port Plug
(16/32 Amp)
LIFT CONNECTOR
LIFT CONNECTOR
FROM HOUSING
FROM HOUSING
AND THREAD
AND THREAD
WIRING THROUGH
WIRING THROUGH
STRAIN RELIEF
STRAIN RELIEF
AND CONNECTOR
AND CONNECTOR
HOUSING.
HOUSING.
ROTATE STRAIN
ROTATE STRAIN
RELIEF
RELIEF
COUNTER-
COUNTER-
CLOCKWISE
CLOCKWISE
TO LOOSEN
TO LOOSEN
INSERT THE END
INSERT THE END
OF A FLAT-BLADE
OF A FLAT-BLADE
SCREWDRIVER
SCREWDRIVER
OR SIMILAR INTO
OR SIMILAR INTO
SLOT AS SHOWN
SLOT AS SHOWN
ABOVE TO DEPRESS
ABOVE TO DEPRESS
CLIP AND RELEASE
CLIP AND RELEASE
LOCKING MECHANISM
LOCKING MECHANISM
ONCE LOCKING
ONCE LOCKING
MECHANISM IS
MECHANISM IS
RELEASED, ROTATE
RELEASED, ROTATE
CONNECTOR
CONNECTOR
APPROXIMATELY
APPROXIMATELY
ONE-EIGHTH
ONE-EIGHTH
TURN COUNTER-
TURN COUNTER-
CLOCKWISE
CLOCKWISE
LOOSEN THE
LOOSEN THE
SCREWS FOR THE
SCREWS FOR THE
RESPECTIVE WIRE
RESPECTIVE WIRE
TRAPS; INSERT
TRAPS; INSERT
STRIPPED WIRE
STRIPPED WIRE
ENDS INTO THE
ENDS INTO THE
APPROPRIATE,
APPROPRIATE,
RESPECTIVE WIRE
RESPECTIVE WIRE
TRAPS AND
TRAPS AND
RE-TIGHTEN SCREWS
RE-TIGHTEN SCREWS
RE-INSERT
RE-INSERT
CONNECTOR
CONNECTOR
INTO
INTO
CONNECTOR
CONNECTOR
HOUSING
HOUSING
ROTATE
ROTATE
CONNECTOR
CONNECTOR
ONE-EIGHTH
ONE-EIGHTH
TURN CLOCKWISE
TURN CLOCKWISE
UNTIL LOCKING
UNTIL LOCKING
MECHANISM
MECHANISM
RE-ENGAGES;
RE-ENGAGES;
RE-TIGHTEN
RE-TIGHTEN
STRAIN RELIEF
STRAIN RELIEF
BY ROTATING
BY ROTATING
CLOCKWISE UNTIL
CLOCKWISE UNTIL
TIGHTENED
TIGHTENED
STEP #4
STEP #4
STEP #1
STEP #1
STEP #2
STEP #2
STEP #3
STEP #3
STEP #5
STEP #5
STEP #6
STEP #6
STEP #7
STEP #7
