Page 30 of 42
INSTRUCTION MANUAL
ARI-6000-100W
RF Power Amplifier
SECTI ON 5
-
OPERATION
1912 1 E l T o ro R d
●
Si l vera do, Ca lifo rni a 9 26 76
●
(9 49) 459 -96 00
●
co m-p o wer. com
REV011718
COMMAND
OPERATION/RESPONSE
REV?
Returns the current Revision in the form X.XX.
NAME?
Returns Name of the Amplifier (Needs to be set first for a return response).
NAME xxxxxxx
Sets the Name of the Amplifier
(Up to 31 Characters).
*MODEL?
Returns the Model Number of the Amplifier
(Needs to be set first for a return response).
*SERIAL?
Returns the Serial Number of the Amplifier
(Needs to be set first for a return response).
*= May not be displayed if Option was not purchased.
Note that the above commands are only available during normal operation (i.e.,
they are not available when either the Configuration or Calibration menus are
active).
5.2.1
Serial Communication Parameters
For both the RS-232 and RS-422 ports, the following settings must be used:
- Data Rate: 9600 Baud
- Data Bits: 8
- Start bits: 0
- Stop Bits: 1
- Parity: None
- Flow control/handshaking: None
