GENERAL DESCRIPTION
CERAMIC HEATING NC-20
GENERAL DESCRIPTION
1. ON/OFF switch (operation mode)
2. Thermostat
3. Carrying handle
4. Fixing screws
5. Base
6, Air blowing opening
7. Air inlet
TECHNICAL DATA
- power: 200W
- supply voltage: 230V ~50Hz
2
1
3
5
4
7
2
6
PURPOSE OF THE DEVICE (CERAMIC HEATER)
HOW TO USE THE APPLIANCE
Ceramic Heater NC20 is designed for use both in living quarters and small workshops . Despite its small size device
has many advantages , the largest of which are: optimized design, and modern usage of ceramic heating
element.
Ceramic technology allows more efficient operation of the heater, this is way device heats up quickly and
evenly. Switch with 3 modes and adjustable thermostat allows precise tare operation of the device. Safety
provides a double security system - an additional thermostat and thermal fuse. The use of a universal base allows
you to comfortably carry and set the device to the desired angle, as well as its installation on the wall. The whole
completes robust metal housing.
Please read this instruction manual carefully before use and operate the heater properly
After unpacking the appliance, make sure it has not been damaged during transport.
In case of any doubts, do not use the appliance until consulting a service centre.
- Put the appliance onto a flat, stable and high temperature resistant ground.
- Turn the switch (1) to position “O” (appliance turned off)
- set the angle of the heater. To do this, turn the screws (4) left. Do not unscrew them completely, select the
angle of the slope, and then turn the knob to the right until it stops.
- connect the appliance to a power source with parameters in accordance with the Instructions for Use.
- choose operation mode by turning the knob (1):
GB
Photo 01
cool air
hot air
very hot air
