Page | 22
Verve Hybrid
Switching Flatbed and Roll to Roll from Software
Follow these steps to switch Flatbed to Roll to Roll unit using the software:
Step 1:
Click on the
Main Menu
→
Tools
→
HW Setting
path (Refer to Fig 23). The
Printer HW Setting
dialog
box appears, as shown below:
Fig 27: Converting Roll to Flatbed
Step 2:
Select the
Use Flatbed
check box when using Roll to Roll printing (Refer to Fig 27).
Step 3:
After this, click on the
OK
button to save the setting (Refer to Fig 27).
Steps for Flatbed Printing
Step 1:
Select the Use Flatbed check box for using the Flatbed printing and then restart the machine.
Step 2:
Set the base value 116485.
Step 3:
Recheck the bi-direction calibration.
Steps for Roll to Roll Printing
Step 1:
Unselect the Use Flatbed check box for using the Roll to Roll printing and restart the machine.
Step 2:
Set the base value 62000.
Step 3:
Recheck the bi-direction calibration.
Note:
Other calibration value remains same.
Dry Movement Test
Run the full (3200/2000 mm) dry print command (without Ink and Head) to verify the functioning of the
printer like XYZ axis, sensors, Limit Switch, etc.
