Page
43
of
50
SOFTJET GRAND
9.
LVDS is not connected
properly
10.
Incorrect pulley is used
Case 9:
Connect LVDS properly.
Case 10:
Use compatible pulley by
contacting Head Office.
Printer
Manager Not
Showing
“Ready”
1.
USB
Cable
is
Loosely
Connected to the Printer
2.
USB Cable is Faulty
3.
Printer not Initialized
4.
USB driver is not Installed
5.
Main Board and Head
Connector Board (HCB) is not
compatible
(an
error
appears)
Case 1
: Tighten the USB cable.
Case 2
: Replace the USB cable, if faulty.
Case 3
: Please refer to the
“
PRINTER NOT
INITIAL
IZING”
section.
Case 4:
Please refer to the “
Installing the
Printer Manager
” section.
Case 5
: Kindly contact to the Head Office or
CES.
Carriage
Stops During
Printing
1.
USB cable is loose or faulty
2.
Open heavy file that can slow
down the data transfer
3.
Ground wire is disconnected
4.
Encoder Scale is having ink
stains
5.
Pulley teeth wear out or belt
is slipping
6.
Ripped file is having error
7.
Check I/P and O/P voltage in
24V SMS (16.5 A) on full load.
Voltage drop, if any.
Case 1
: Tighten the USB cable or replace it,
if required.
Case 2
: Use compatible and small size
images for printing.
Case 3
: Connect the ground wire to the
system.
Case 4:
Check and Replace Encoder Scale
Case 5
: Replace the Pulley or carriage Belt
Case 6
: Correct the ripped file error, if any.
Case 7:
Replace the power supply, if voltage
drop is found and also check the power Inlet
to the machine.
Print Is
Shifting WRT
Fabric Or
Junk Printing
1.
Encoder scale is having ink
stains (print shows vertical
color bands)
2.
Encoder sensor is not clean
Case 1:
Clean the Encoder scale, if stained,
or replace it, if faulty.
Case 2:
Clean the Encoder Sensor or replace
it, if faulty.
Print Is Blur
(Not Sharp)
1.
Improper Head height
2.
Improper head alignment
3.
Recommended ink not used
4.
Ink stored at unfavorable
environment
5.
Head voltage is not properly
fed in Printer Manager
6.
Improper step calibration
7.
Vibration in movement:-
o
LM block is wear out
o
Incorrect
pulley
alignment
Case 1
: Correct the head height by following
the steps given in the
Head Height
Adjustment
section.
Case 2
: Calibrate the printer again by
referring the “
Head Alignment”
section.
Case 3 & 4
: Use only the recommended ink
and stored it in favorable environment
conditions.
Case 5:
Feed the Head Voltage value as
mentioned in the Print Head.
Case 6:
Correct the step calibration using
the Step Calibration section.
Case 7:
Perform the following actions as per
the requirements:
a)
Replace the LM block
b)
Align the pulley with respect to Belt