8-Pin DMD Power Cable
(Remove entire cable
from the game)
14-Pin DMD Ribbon Cable
(Unplug cable from DMD
and leave other end
connected to game)
Figure A
Cable connected to lamp
board mounted to speaker
panel. Not all games use this.
Unplug cable and remove
lamp board if present.
Ground Lug
Carefully remove the translite from the backbox and then lower
the speaker panel to the position shown in Fig. A to gain access
to the backbox.
ALL RIGHTS RESERVED - PATENT PENDING - COPYRIGHT 2012 - COLORDMD DISPLAYS LLC
Installation Instructions
for
WPC
Be sure to turn
OFF
the power to the pinball machine before
installing the ColorDMD display.
Tools Required
:
Remove and save all of the DMD mounting hardware. Remove
the original DMD from the game and store it in a safe place.
1
2
3
STEP
STEP
STEP
!
Disconnect the DMD power and ribbon cables from the DMD.
Unplug the DMD power cable from the high-voltage A/V board
J-604 (see Fig. E), and
remove this cable from the backbox
.
Congratutions on the purchase of a new ColorDMD display. The ColorDMD
will enhance your pinball machine by introducing
color
to the dot matrix
display graphics produced by the game.
If pinball machine has a lamp board mounted to the speaker
panel, disconnect cable and remove the lamp board (see Fig. A).
Store lamp board and mounting hardware in a safe place.
Phillips Screwdriver
5/16" nut driver
1/4" nut driver (if game has a lamp board
mounted to the speaker panel)
STEP
4
•
•
•
