COLORATO CLHR-20WR, Instruction Manual, Page: 6 / 7

Step 4: Drill two holes (Ф8*40) on the wall, its distance is 55mm. Install the hanger (No.4 in accessories list) on
the wall with 2pcs M6*60 (No.3 in accessories list) by the spanner.
Step 5: Fix the heater on the hanger with the bolt M8x60 (No.5 in accessories list), fasten the nut M8 (No.5A) by
Hand and screwdriver.
Step 6: Tilting angle adjustment. Loose the nut M8 (No. 2B), then adjust the tilting angle by hand. The angle is
to be set up to 45°.
Step 7: Finally, fasten the nut M8 (No. 2B) by hand and Screwdriver.
4. How to operate

Plug the heater in the main power, and press the switch on, the pilot lamp

will flash and The heater is in stand-by mode;

Press the key “ON” on the remote control, the buzzer responds one sound. The pilot
will be light. The heater will start work in low power mode in first time using, or work
in the pre-set power model;

Press the KEY “LOW”, set the heater work in 33% of the rated power. The buzzer
responds one bee sound;

Press the KEY “MED”, could set the heater work in 66% of the rated power. The
buzzer responds two bee sound;

Press the KEY “HIGH”, could set the heater work in 100% of the rated power. The
buzzer responds three bee sound;

Press the KEY “OFF”, the buzzer responds one bee sound, the heater Is in stand-by
mode;

Push the switch off, the heater will be power off.