Data Enabler Pro Product Guide
8
Assemble Additional Items
The following additional items are required to mount
and connect Data Enabler Pro.
• 4 mounting screws suitable for the mounting surface
• For installations using metric size conduit, PG21
watertight conduit and fittings for power, and PG13.5
watertight conduit and fittings for data, as required
by local codes
• For installations using US trade size conduit, 3/4 in
NPT watertight conduit and fittings for power, and
1/2 in NPT watertight conduit and fittings for data, as
required by local codes
• CAT 5e or better data cable, as required
• 4-conductor copper wire for luminaire connections,
as required. Standard 3.31 mm2 (12 AWG) stranded
wire is recommended.
• Electronics-grade RTV silicone for installations in
damp and wet locations
• Screwdrivers, wire strippers, and other tools as
needed
Inspect Data Enabler Pro and Accessories
Carefully inspect the box containing Data Enabler
Pro and the contents for any damage that may have
occurred in transit.
We recommend that you ensure your Data Enabler
Pro devices are running the latest version of the
firmware, and update the firmware if necessary, before
positioning and mounting the devices. See page 14 for
complete information.
Position and Mount Data Enabler Pro
Make sure the power is OFF before mounting and
connecting Data Enabler Pro.
1. Each Data Enabler Pro device is identified by a unique
serial number and IP address. The serial number and
default IP addresses are located on a label inside the
Data Enabler Pro housing. If your installation requires
multiple Data Enabler Pro devices, record the serial
numbers (DMX) or IP addresses (Ethernet) in a
layout grid (typically a spreadsheet or list) for easy
reference.
2. Assign each device to a position in the lighting design
plan.
3. Position each Data Enabler Pro device in its
designated mounting location. Make sure the
mounting surface is flat, suitable for the mounting
hardware, and clear of debris and other obstructions.
The overall dimensions of each Data Enabler Pro
device are 267 mm (10.5 in) wide x 138 mm (5.4 in)
deep x 87 mm (3.4 in) high. Make sure the mounting
location allows enough space around the housing for
air to move freely around the device. Be careful not to
obstruct or submerge the vents on either side of the
Data Enabler Pro housing.
We recommend orienting Data Enabler Pro so that
power and data cables enter the input side of the
housing (the side with four threaded openings), and
luminaire cables exit the output side (the side with two
threaded openings).
4. Use four suitable mounting screws to secure Data
Enabler Pro to the mounting location.
Do not obstruct or
submerge the vents
Installation
Multi-language installation instructions can be found at:
https://www.colorkinetics.com/global/products/pds/dataenablerpro
Data Enabler Pro
8 mm hex wrench
3 mm hex wrench
Flat blade screwdriver
Installation Instructions
3 mm hex
8 mm hex
