VISCO
550
Collomix GmbH
10
Version 1.1-17
5.2
Set-up the equipment
The machine is delivered on a wooden pallet packaged in recyclable cardboard. Check the packaging
immediately upon receipt and the equipment when unwrapping it for any visual external defects.
Keep all parts of the original packaging for a possible necessary return.
The machine shall be operated only by qualified personnel using suitable lifting equipment e.g. a
forklift truck to be lifted from the palette. Only move the fork in from the front or back to avoid
damaging the transport rollers (5.3)!
Pay attention to the weight of the machine specified in 11.1 not to exceed the permissible load of the
floor.
Do not operate the machine on the shipping pallet or on any other suitable sub-surfaces.
Before installation, ensure that there is a sufficiently large working area available in front of the
machine. The doors of the machine may not protrude into aisles or travel paths when opened!
Check the level of alignment and the stability of the machine with a spirit level. Adjust any unevenness
in the floor with the height-adjustable legs (1).
5.3
Transport rollers
The mixer is equipped with two transport rollers on the bottom of the housing. These transport rollers
can be made to protrude out of the mixing compartment by turning a screw on each side of the
machine.
•
Use a suitable tool size SW 17 to turn out the transport rollers on both sides of the machine.
•
The door must be opened for the machine to be handled safely during transport.
•
Carefully tilt the mixer and move it.
•
When you are finished moving the machine, turn the transport rollers back.
5.4
Mains connection
Pay attention on proper protection of the electrical circuit such as described under 11.1 Only use Type
B residual-current devices (RCD).
Place the mains cable in a way to prevent from stumbling or snagging.
5.5
Trial run
A trial run with an empty mixing container must be conducted when first starting the machine or after
maintenance and repair work in order to check the proper function of the machine.
Remove all accessories, tools, and other loose parts from inside the machine.
WARNING
Risk of injury due to protruding parts
Parts may protrude from the equipment.
•
Always work diligently on the equipment and in close proximity of the equipment.
•
If the machine is not used and turn it off on the main switch.
Transport rollers
Machine foot
Set-up and alignment
