LevMix
Collomix GmbH
85080 Gaimersheim/Germany
Page 10
Rev. 2
Ref. 37101 (US 110)
•
To start up the mixer, press the green “I” START button. The mixing tool will start to rotate.
•
Switch on the vacuum cleaner if fitted.
•
Fill the mixing tub with water and then add the mixing material step-by-step.
•
To turn off the machine, press the red “0” OFF button. The machine will run to a stop.
•
Pull out the power plug before you start to pour the ready-mixed material.
•
Taking the mixer by the handle with both hands, move it to where you want to pour the
material.
•
To pour, release the mixing tub by pressing the pedal with your foot. Keep hold of the han-
dle with both hands when you do so. Then tip the mixing tub by the handle until material
starts to flow out over the pouring spout.
•
If you want to distribute the material over a larger area, move the mixer in the direction you
require. When doing so, take care to always move away from the fresh material. This is to
make sure that you do not move the wheels into the mix.
•
Once the mixing tub is empty, move it back into the vertical position again until the foot
pedal locks again.
The machine comes with an undervoltage trigger. The machine comes to a stop if this is trig-
gered. This can be caused by the following:
•
A drop in the voltage in the mains power supply
•
A cable which is too long
•
A cut in the power connection
Restart the machine when the fault has been rectified.
High-quality design floors:
If the finished mix has to be screened as well, a fine screen must be attached to the spout in
order to hold back very small lumps. This is available as an extra accessory (Art. No. 71064/
screen)
IMPORTANT:
Please observe the information in the technical data sheets issued by the manufacturer of the
material.
The amount of time required for mixing will vary according to the quantity and flowability of
the material.
For some particularly sensitive surface coverings it can be helpful to pour the mixed materi-
al through a screen with a fine mesh. This type of screen can be fitted to the pouring spout
(accessory).
Some materials are susceptible to the formation of air inclusions during mixing which do no not
disappear on their own. To remove them, turn the mixer off for a short time to allow the air to
escape. Then restart the mixer and complete the mixing operation.
Opera琀椀on
WARNING
Risk of injury from the rotating mixing tool.
Do not reach into the mixing compartment or use any tools inside it while mixing is in prog-
ress.
