4
EN
G
LI
SH
Safety
• Make sure that the voltage used is suitable for the appliance. Refer to the rating plate.
• Always disconnect the appliance from the power supply before assembling or cleaning.
• Remove the glass jar from the motor housing for cleaning. Cutting blades/knives
at the bottom of the glass jar are very sharp and can cause personal injury if the
appliance should start accidentally.
• Never put your hand or other unsuitable object into the blender when in use!
• Be careful when the replacing or removing the blade assembly from the jar, as
the knives are very sharp.
• To avoid electric shock, protect the appliance and its power lead from moisture or liquids.
• The power lead should be checked regularly. Never use the device if the power lead or
plug is damaged.
• The power lead must be changed if damaged in order to avoid the risk of chock or fire,
but this should only be done by the manufacturer, qualified service facility
or professional.
• Never lay the power lead over hot surfaces or sharp edges and corners.
• Always disconnect the appliance from the power supply by holding and pulling
the plug, do not pull the power lead.
• Never let children use the appliance without adult supervision.
• Make sure that the parts of the appliance are correctly assembled and that
the appliance is switched off before connecting to the power supply.
• Never use accessories other than the ones included.
• Never turn on the appliance when it is empty.
• Never use the appliance in the vicinity of heat sources e.g. the cooker.
• Never use the appliance for anything other than it is intended.
• For indoor use only.
Getting started
Clean the appliance and its attachments before using for the first time.
See section
“Care and maintenance”
.
1. Prevent unintended starts by pulling out the plug from the mains before the blade
assembly and glass jar are assembled.
2. Carefully place the rubber seal (4) on the blade insert (5). Take care as the blades
are sharp.
3. Place the blade insert in the locking ring (6) and screw on the glass jug clockwise
until it stops. Make sure that it is firmly in place.
4. Check that the function dial is set to
0
.
5. Place the glass jug on the motor section (8) and turn clockwise until it locks and
is securely in place.
