8-9
Periodic Maintenance and Adjustment
To Install
1. Place the console in its original position.
2. Install the parking brake lever boot.
3. Install the seats.
CAUTION:
When installing the console, be sure not
to pinch the cables or wires.
Make sure that the groove at the bottom
of the parking brake lever boot and the
drive select lever boot fits securely
around the edge of the hole in the
console.
Engine Oil And Oil Filter Cartridge
The engine oil level should be checked
before each operation. In addition, the oil
must be changed and the oil filter cartridge
replaced at the intervals specified in the
periodic maintenance and lubrication chart.
To Check The Engine Oil Level
1. Place the vehicle on a level surface.
2. Remove the console. (See page 8-8 for
console
removal
and
installation
procedures.)
3. Check the engine oil level on a cold
engine.
NOTE:
If the engine was started before checking the
oil level, be sure to warm up the engine suff-
iciently, and then wait at least ten minutes
until the oil settles for an accurate reading.
4. Remove the engine oil filler cap and wipe
off the dipstick with a clean rag.
5. Insert the dipstick in the oil filler hole
(without screwing it in), and then remove
it again to check the oil level.
Summary of Contents for OUTFITTER 700-L
