15
16
OPERATING INSTRUCTIONS
QUICK RELEASE CHUCK (FIGURE G)
NOTE: The chuck accepts 1/4 inch (6.35 mm) hex accessories only.
Place the switch in the locked off (center) position or remove
battery pack before changing accessories.
To install an accessory
, pull the chuck collar
(3)
away from the
front of the tool, insert the accessory, and release the collar. The
accessory is locked in place.
To remove an accessory
, pull the chuck collar
(3)
away from the
front of the tool, remove the accessory and release the collar.
Figure F
Figure H
Figure I
ON BOARD BIT STORAGE (FIGURE H)
Two bit storage slots
(6)
is built-in to the area just above
the battery.
LED WORK LIGHT (FIGURE I)
There is a worklight
(5)
located just above the trigger switch
(1)
.
The worklight will be activated when the trigger switch is squeezed.
NOTE: The worklight is for lighting the immediate work surface
and is not intended to be used as a flashlight.
FORWARD/REVERSE CONTROL BUTTON (FIGURE E)
A forward/reverse control button
(2)
determines the direction of
the tool and also serves as a lock off button. To select forward
rotation, release the trigger switch and depress the forward/
reverse control button on the right side of the tool. To select
reverse, depress the forward/reverse control button on the left
side of the tool. The center position of the control button locks
the tool in the OFF position.
When changing the position of the control button, be sure the
trigger is released.
NOTE:
The first time the tool is run after changing the direction of rotation, you may hear a
click on start up. This and the impacting noise that the tool makes is normal and does not
indicate a problem.
This page is intentionally left blank
Figure E
