4010004062 (20081122)
STITCH LINE
Attach Shelter to Frame
1.
With the frame still partially set up,
clip the center of the Screen House
to the center hub. (illus. 3)
2.
Starting towards the center of the
Screen House, clip the shelter fabric
to the poles.
Complete Shelter
1.
Fully extend each pole by straightening
all shock-corded pole sections.
2.
Insert the pin on the pin and ring
system, at the corner of the Screen
House into the the pole end.
(illus. 4), (illus. 6)
3.
Repeat for remaining poles.
4.
Adjust poles to pull the shelter
taut and stake down through
the fabric loops at the end of
pin and ring. (illus. 5), (illus. 6)
5.
Attach guy lines to fabric
guy loops at each corner
and stake out (illus. 6)
Start by attaching the center of the
Screen House to the pole hub.
illus. 6
Completed shelter with
guy lines staked out
illus. 3
Screen House clipped to
partially assembled frame
illus. 4
Insert into the
pole end
illus. 5
Stake through
stake loop
Things You Should Know:
•
Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside of your tent. Condensation is caused by water vapor from your
breath, perspiration, or any wet clothing inside the shelter. It is NOT LEAKAGE through the shelter fabric. It can be minimized by removing wet clothing from
your shelter and by providing good ventilation through the shelter.
•
Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the shelter fabric and its coating resulting in leaks or loss
of flame-resistant properties.
•
Never store shelter, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your shelter.
Use a separate storage bag.
•
Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE SHELTER TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE
OR PERSONAL INJURY.
•
Shelter poles should not be left telescoped together during storage.
•
Do not leave your shelter set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to
become discolored.
WARNING: Keep all flame and heat sources away from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application
of any foreign substance to the tent fabric will render the flame-resistant properties ineffective.
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 in the United States • www.coleman.com
Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions
20B Hereford Street • Brampton (Ontario) L6Y 0M1
1 800 387-6161 in Canada • www.coleman.com
MADE IN BANGLADESH • PRINTED IN BANGLADESH
© 2008 The Coleman Company, Inc.
Coleman
®
, , and are registered trademarks and Insta-Clip
TM
is a trademark of
The Coleman Company, Inc.
