-- 9 --
5. Position the height of the mixer head on high-sp ed models by loosening the collet and positioning the
The controller can be placed on any flat surface within 6 feet of the mixer head and can be
6. To insta
port platform proceed as follows:
rm into the lower hole on the tank clamp and tighten
b.
troller on platform and proceed to step 8.
7. To
unting studs on bottom of controller.
n.
clamp and
d.
ning knob on pivot mount bracket, adjusting position
8. Connec
the mixer head and the controller rear panel.
er source, either a 90-130VAC
11.
mixer head in the On ‘1’ position.
The mixer is now ready to operate.
e
shaft.
Note:
mounted on a support platform (not supplied) or a pivot mount (not supplied). Refer to
ACCESSORIES for part numbers. To attach the support platform, proceed with step 6. To
attach the pivot mount, proceed with step 7. If controller is placed elsewhere, proceed with
step 8.
ll the sup
a. Slide the mounting rod of the support platfo
clamp.
Place con
install the pivot mount proceed as follows:
a. Remove the two cap nuts from the mo
b. Position pivot mount bracket over two studs, reinstall two cap nuts and tighte
c. Slide the mounting rod of the pivot mount bracket into the lower hole on the tank
tighten clamp.
Adjust position of controller by first loose
and then retighten knob.
t the 6-foot cable between
9. Check that the rear panel ON-OFF switch is in the OFF position.
10. Connect the 6-ft line cord from the controller to the appropriate pow
50/60Hz 3-wire, grounded power source.
Place the red safety switch on the top of the
not subject to splashes or spills.
•
Be sure the SPEED control is fully counterclockwise
before the POWER switch is placed in the FWD or REV
positions (Stir-Pak models only).
•
Check that all cords are clear of any moving parts and
any kind of fluid.
•
Avoid wearing loose clothing that may be caught by a
rotating mixer shaft.
•
Use care when setting the operating speed of the
mixer. Operation at high speeds in small mixing
vessels could result in hazardous splashing on the
operator and equipment.
•
Be sure the SPEED control is fully counterclockwise
before the POWER switch is placed in the FWD or REV
positions (Stir-Pak models only).
•
Always wear appropriate eye protection when mixing
