INSTALLATION AND SETUP PROCEDURES
The mixer heads are equipped with an adjustable-tilt mounting assembly. The mounting assembly is designed
to be attached to an optional mixer support stand or tank clamp. Components supplied as part of the mixer
package include the following:
•
Mixer head with 6-ft cable
•
Precision controller with 6-ft line cord
•
3-jawed chuck on high-torque mixers
•
⅜
-inch collet on high-speed mixers
•
Adjustable-tilt mounting assembly with support rod
Installation of Adjustable-Tilt Mounting
•
Never insert or remove the mixer shaft/impeller while the mixer
shaft is rotating.
Perform the following steps:
1. Attach mixer head to adjustable-tilt mounting assembly as follows:
a. For Stir-Pak models 50007-10, -20, and ServoDyne models 50008-10, -20, attach mounting assembly
with four screws and lock washers. (See Figure 3a)
Figure 3a: 50007-10, -20 and 50008-10, -20 mixer head mounting
b. For Sir-Pak models 50007-30, -40, and ServoDyne models 50008-30, -40, attach mounting assembly
with two screws and lock washers. (See Figure 3b)
Figure 3b: 50007-30, -40 and 50008-30, -40 mixer head mounting
Note:
The mixer is now ready to be attached to a support stand or to a tank clamp (not supplied).
Recommended stands, tank clamps, and a double (rod) clamp are available through Cole-
Parmer. Part numbers are listed in the ACCESSORIES section.
-- 5 --
