Cole Parmer PolyStat CC1080, Manual

Page: 20 / 32

- 18 -
9.3 Adjusting the variable temperature set point

Press the menu button
3
.
A left–justified “ S ” appears in the small display 5 (for s et point temperature
adjustment).

Increase or decrease the value shown in the display 6 with buttons 7 .
The first degree of temperature change starts slowly but then the rate of
change in the display becomes faster.

When the desired set point value is displayed, press the enter button
8 .
The selected value is stored and used as the new temperature set point.
NOTE:
The new value is not stored until the enter button
8
is pressed. If
not depressed, the circulator continues to use the old set point value.
After the enter button 8 has been depressed, the value remains stored
(even in case of a power failure).
After a short time delay, display 6 automatically returns to the actual tem-
perature display.
9.4 Adjusting the fixed temperature set points F1 to F3
This CC1080 can permanently store up to three fixed temperature set
points which can be used when required.

Press the menu button
3
.
The small display 5 shows F1 (for f ixed temperature set point 1 ), F2 or F3 .

Press buttons 7 to increase or decrease the value shown in display 6 .

Press the enter button 8 .
After the enter button 8 has been depressed, the value remains stored
(even in case of a power failure).
The selected value is stored as fixed temperature set point F1, F2, or F3
and is used as the currently valid set point value.
After a short time delay, display 6 automatically returns to the actual tem-
perature display. At the same time the small display 5 shows which tem-
perature set point, S, F1, F2 or F3, is currently in use.
To activate another set point, press the menu button 3 until the designator
of the desired set point (e.g. “ S ” ) is shown on display 5 . Without changing
the value press button 8 to confirm the desired set point.
7
6
3
8
5
7
6
3
8
5
7
6
3
8
5